Tel: +44   (0)1903 259318

    Email:   info@pointeperformance.com

 

UK flag copy

Hello World !

PointePGrabLogo

Your Shopping Cart 

dancerlilactutu P1020322 PrepPointeShoe

             

 

1 & 2. DARNING the tips will slightly increase the life of the shoe and add more grip. Alternatively suede toe caps can be applied with glue. Large curved darning needles are best and darning thread/stranded cotton same colour as the shoes.

Method: Slightly soil the satin by wearing the shoe and rotating the tip to indicate where it comes into contact with the floor most.

Start as near as possible to the leather sole, stitch a series of bars of stranded thread to and fro across the pleats until they reach as far across as where the soiling indicates.

Ensure pick up of enough satin with the needle.

The first line should pick up the satin with every stitch. Now start near the sole, blanket stitch over each bar, linking the rows by pushing the needle through the loops of the row below and continue back and forth until all rows are covered.

Satin may be darned at the sides of the foot where big and little toes joints may cause faster wear, but not essential.

 

 

3 & 4. SEWING ON RIBBONS

Cut the ribbon into four equal length pieces. You will need two lengths for each shoe. If using Elastorib or other ribbons with integrated elastic for the achilles tendon area, measure lengths with extra care, to ensure the correct position of the elastic area over the achilles tendon before cutting the ribbon.

Fold down the satin upper at the heel end until it rests flat against the sock lining (insole).

Place the ribbon at the fold's edge or inside the crease and mark it with a pencil on both sides of the ribbon on the inside of the shoe to mark its position.

Sew the ribbon to the inside lining making sure that the ribbon has sufficient depth down into the sides of the shoe and also sew across the inside of the binding, taking care not to stitch the elastic/string drawstring. The stitching should not be visible through the satin on the outside of the shoe.

Personal preferences will decide if the ribbon is to be sewn at a right angle to the binding or more angled.

Repeat for other shoe.

 

5 - 7. TYING RIBBONS

To tie, the shoe should be with the foot flat on the floor, perhaps in a kneeling position. Do not tie the shoes with the foot en-pointe or with the leg straight as this allows no flexibility of the ankle and could prevent full movement when doing demi-plies.

Bring one ribbon forward, cross it over the instep and wind it flat and snug around the ankle. Hold it firmly.

Take the second ribbon forwards, crossing it over the other flat and right around the ankle and make a small double knot it in the hollow between the ankle bone and the achilles tendon, on the inside of the ankle. The ends of the ribbon can then be pushed down behind the fastened ribbon in the small hollow, so that no ends are visible.

 

 

8 - 9. WORKING THE SHOE IN

Always try to work the new shoe in before wearing for practice class or even more so if being used for a stage performance.

Soften the block slightly by moulding them in the palm of your hand. Most pointe shoes are biodegradeable and the heat from the hands is sometimes sufficient to start to soften the shoe. This process will continue with the heat from the feet when worn.

Start to ease the insole slighlty at the demi-pointe area, where the ball of your foot would be, by pressing with both thumbs inside the sole of the shoe against the floor. Do not work or bend higher up in the shank (mid-sole) as this is where you need the shoe to give you most support.

You can encourage the shoe to arch a little to hug the sole of your foot, in particular just below the pad of your heel, where the heel ends and before the arch of your foot begins. This way, the sole will conform to the shape of your foot better when en-pointe, but still remain strong in the centre of the shank.

Wear the shoes at home, walking around in them, rising to quarter, demi and three-quarter pointe and occasionally rise through the whole foot to full pointe on one shoe, then the other.

 

IF YOU ARE NEW TO POINTE WORK, WAIT FOR YOUR TEACHER TO SUPERVISE YOU THROUGH YOUR MOVEMENTS.

INCORRECT AND POOR MOVEMENT PATTERNS WILL BE LEARNT AND RETAINED BY YOUR MUSCLE MEMORY,  THIS COULD SLOW YOUR PROGRESS, AFFECT YOUR TECHNIQUE AND COULD CAUSE YOU INJURY.

Copyright ©  Pointe Perfromance. 2012.  All Rights Reserved

Copyright © Pointe Performance 2012

332340_10150297162029074_374215009073_7711267_7354

Copyright Pointe Performance 2012

Preparing Your Shoes

P1020337

Pointe Shoe Care